FHA Appraisal Walkthrough Checklist
What an FHA appraiser checks on site, room by room, and what to fix before the final visit.
A real, editable checklist below — tick, tap a line to rewrite, drag to reorder.
Tick the circles, tap any line to change it, drag the dots to reorder.
Saved in this browser. Send it to Clear to keep it on your phone.
Get this list on your phone
Point your phone's camera at the code.
Timing matters on an FHA appraisal. The report is valid for 180 days after issue, per Chase, so a long closing may need the lender to recheck value. Repairs the appraiser flags generally need finishing before the return visit for the final inspection, or the loan can hold; Chase notes some may be completed after closing with funds escrowed. Cardinal Financial notes the visit has two jobs: setting value and checking HUD minimum health and safety standards. This list covers the on-site walkthrough for appraisers, buyers and sellers. It leaves out comparable sales and pricing.
Why these items are on the list
- Check foundation for cracks. Structural defects and water damage are on the list; serious ones can stop the loan.
- Inspect roof and siding. Look for missing shingles, holes in siding and leaks. Trinity sets two years of remaining life as the minimum.
- Check gutters, chimney and porches. Include stairs and railings in the same pass.
- Look at fencing and pool. Leaning or broken fencing is flagged, and swimming pools must be up to code.
- Test doors and windows. Doors should open and close properly. Each room needs a window or door to the exterior for fire escape.
- Confirm handrails on all stairs. Missing handrails are a common flag, and steep staircases without them count as hazards.
- Check paint in pre-1978 homes. Chipped or peeling paint is flagged in homes built before 1978; lead-based paint is the concern.
- Look for exposed wiring. Open junction boxes and loose wiring need repair before approval.
- Confirm power in every room. Each room needs electricity; check the panel for visible hazards too.
- Verify utilities work. Water, sewage, heat and electricity all need to be functional.
- Test the heating system. Trinity says it must hold 50 degrees Fahrenheit in all living areas.
- Check smoke detectors on every floor. Trinity Inspections lists working smoke detectors on every floor as a safety requirement.
- Check kitchen appliances and sink. A stove and refrigerator usually sold with the home should be present and working. Look for sink leaks.
- Inspect bathrooms for leaks. Check the toilet, sink and tub or shower. Each bathroom needs an exhaust fan or window.
- Check plumbing and water pressure. Major leaks are flagged. Pressure and drainage should be adequate and the water potable.
- Inspect the attic. No active roof leaks or moisture damage; access to the attic space is required.
- Check basement and crawl space. Basement moisture or standing water, past or present, is flagged. Crawl spaces need natural ventilation.
- Look for wood-destroying insects. Chase lists wood-destroying insect infestations as a barrier to FHA approval.
- Confirm vehicle and emergency access. Property access should be safe and reasonable, including for emergency vehicles.
- Note nearby outside hazards. A leaking oil tank, a waste dump or heavy noise, such as near an airport, can count.
- Flag incomplete renovations. Unfinished work is on the common-issue list.
- Finish flagged repairs before return visit. Minor fixes done before the final inspection keep the loan moving; Chase allows some post-closing repairs with escrow.
- Recommend an independent inspection. HUD strongly encourages one but does not require it; buyers sign a disclosure about it.
Walk the property with the list open on your phone and tick as you go. Share it with the buyer or seller so everyone sees the same open items.
When to use it
Use it before the appraiser's site visit, or at any walkthrough where you want to catch FHA flags early.